Evaluation of The Resistance of Deviation Between Levels of Reinforced Concrete Structures Using Zone 3 Design Spectrum in Risk Category II Buildings

Authors

  • Farhan Fadlirahman Universitas Swadaya Gunung Jati
  • Arief Firmanto Universitas Swadaya Gunung Jati

DOI:

https://doi.org/10.58860/jti.v5i4.944

Keywords:

Inter-Story Drift, Design Spectrum, SNI 1726:2019, Seismic, P-Delta, Risk Category II

Abstract

This study evaluated the interstory drift performance of the reinforced concrete structure of the Mie Gacoan Central Plant 3 building in Kertajati, Majalengka, Indonesia. Located in an industrial area near the Baribis Fault, the building required a seismic performance assessment to determine its compliance with applicable structural safety requirements. The analysis employed the response spectrum analysis method in accordance with SNI 1726:2019, using ETABS version 22. The results indicated that the structure had a fundamental vibration period of 0.424 seconds in both principal directions, satisfying the prescribed period limitations. The minimum cumulative modal mass participation requirement of 90% was achieved in the eighth mode for the X direction and the seventh mode for the Y direction. Because the initial dynamic base shear was lower than the equivalent static base shear, response spectrum scaling was performed, resulting in scale factors of 1515.27 and 1884.36 in the X and Y directions, respectively. The maximum calculated interstory drift occurred at the second story in the Y direction, reaching 25.014 mm, which remained below the allowable limit of 61.538 mm. Furthermore, the P–Delta stability coefficients for all stories were below 0.10, indicating that second-order effects could be neglected under the applicable stability criteria. These findings demonstrated that the analyzed structure satisfied the evaluated seismic design requirements of SNI 1726:2019 concerning fundamental period, modal mass participation, base shear scaling, interstory drift, and P–Delta stability. However, the results should be interpreted within the scope of the structural model and the seismic performance criteria assessed.

Downloads

Published

2026-11-19